Blue Iris Stained Glass Privacy Static Cling Window Film 24" x 36"

These window films create the look and feel of stained and decorative glass. These translucent films have an image that is visible from both sides of the window, providing privacy and style, while allowing natural light to enter the room.

An inexpensive alternative to traditional window coverings like blinds or drapes,these films are recommended for use in any room requiring continued privacy as well as specialty windows like arches, sidelights and transoms.

Our films apply easily to any smooth glass surface without the use of adhesives and are easily removed if needed. They can be trimmed or combined to fit any size window. The 24" x 36" films have a repeating pattern left to right and top to bottom and can be used either vertically or horizontally.

Detailed instructions included.
Made in the USA

THIS EASY TO APPLY FILM IS ADHESIVE FREE BUT CLINGS TIGHTLY WITHOUT CURLING.

> This easy to apply film is adhesive free and contains the essence of real glass for authentic sparkle and shimmer.

> 90 to 95% UV protection depending upon the film. Filters UV rays and helps save energy. (Keeps room cooler in the summer and warmer in the winter.

> Improves privacy and security while letting in light.

> Diffuses glare and softens harsh sun.

> Obscures a bad view

> Applies with just a spray bottle of water and a couple drops of liquid soap.

> Is easy to trim to size

> Easy to clean

> Not affected by steam or moisture

INSTALLATION INSTRUCTIONS

> Measure window and trim film on a smooth flat surface.

> You will need to leave approximately 1/8 inch space between the film and the edge of your glass so that water can be removed from under the film. 

> Remove all dirt and debris from the glass using any commercial glass cleaner.

> Add a few drops of liquid soap to a spray bottle of cold water. Spray a generous amount of the mixture on the glass. 

> MAKE SURE THE FILM AND THE BACKING PAPER DO NOT GET WET BEFORE REMOVING THE FILM FROM THE BACKING PAPER. If these get wet this may ruin your film as it will be difficult to remove the film from the backing paper.

> Peel film from backing paper, keeping backing paper dry and film lint and dust free.

> Position film on the glass. The side of the film applied to the backing paper is the side that will be applied to the glass.

> Squeegee out excess water with squeegee or credit card until all bubbles and water have been removed.

> Do not apply film to glass while the glass is hot.